- Sep 10, 2017
- 2
- 0
- 510
Hey there.
I just added a water cooling loop to a system that was previously running on air. No components changed whatsoever. When I booted up the system after getting the water loop finished, the display is saying "No Signal." I've reset the CMOS and tried single sticks of RAM in various configurations. No dice. Again, the components all worked when they had their stock air cooling solutions on them. Any ideas?
Intel 6600k
ASUS Sabertooth TUF Z170S
Ballistix DDR4
HX 750i
ASUS GTX 1060
I just added a water cooling loop to a system that was previously running on air. No components changed whatsoever. When I booted up the system after getting the water loop finished, the display is saying "No Signal." I've reset the CMOS and tried single sticks of RAM in various configurations. No dice. Again, the components all worked when they had their stock air cooling solutions on them. Any ideas?
Intel 6600k
ASUS Sabertooth TUF Z170S
Ballistix DDR4
HX 750i
ASUS GTX 1060
Facebook
Twitter
Instagram