Hello! I've recently put together a new amd ryzen system, but I cannot get a signal on my monitor.
The system I have is :
MOBO: Asus Prime B350-plus
CPU: Ryzen 7 1700
Cooler: The stock wraith spire cooler it comes with
GPU: Asus gtx 1050 phoenix
Ram: Corsair Vengeance 8gb 2666 MHz c16 (also tried with different stick of ram)
PSU: Corsair CX550M
hdd+ssd for storage (removed after the first few failed attempts to boot)
PSU: Corsair CX550M
So this is what happens, I plug everything in, connect the monitor, press the power button and then the PC powers up, fans start spinning (chassis, cpu cooler, gpu fan), then after a couple of seconds it powers off, everything stops spinning, then again few seconds later it turns on again and then stays on, fans keep running but my monitor gets "No display", I let it run like that for a minute or two, then power it off.
Any suggestions please? Maybe someone who has been through a similar situation?
These are the steps I've taken.
I try to connect through DVI-D to DVI-D, tested the monitor on a different pc and it worked.
Tested with a stick of 4gb kingston furyX that I had.
Tried to connect to the TV through HDMI (random suggestion from a post), tried to remove the reset button from the system panel(random suggestion from some post).
Tried a different RAM slot.
Tried to reset CMOS by circuiting, removed the battery and put it back.
Tightened the cpu cooler screws, loosened the cpu cooler screws(both were suggested).
Please, if anyone knows what's wrong / has some suggestions, leave a comment.
P.S. The stock cooler needed some force for the screws to get in place, Not sure if I did something wrong or it is supposed to be a tight fit. Also, the previous system I built was with an intel pentium, asus b250-plus, same GPU and it would not get signal from the gpu until I installed windows and latest drivers (kinda weird but yeah)
**EDIT**
I've now gotten a buzzer, which only does 1 short beep after the pc turns off and on again.
Removing the ram, and trying to start without it does no beep but no turning off and on either. Without any ram all the fans start spinning (cpu cooler led is off) and it just keeps going like this, It does not restart itself.
The system I have is :
MOBO: Asus Prime B350-plus
CPU: Ryzen 7 1700
Cooler: The stock wraith spire cooler it comes with
GPU: Asus gtx 1050 phoenix
Ram: Corsair Vengeance 8gb 2666 MHz c16 (also tried with different stick of ram)
PSU: Corsair CX550M
hdd+ssd for storage (removed after the first few failed attempts to boot)
PSU: Corsair CX550M
So this is what happens, I plug everything in, connect the monitor, press the power button and then the PC powers up, fans start spinning (chassis, cpu cooler, gpu fan), then after a couple of seconds it powers off, everything stops spinning, then again few seconds later it turns on again and then stays on, fans keep running but my monitor gets "No display", I let it run like that for a minute or two, then power it off.
Any suggestions please? Maybe someone who has been through a similar situation?
These are the steps I've taken.
I try to connect through DVI-D to DVI-D, tested the monitor on a different pc and it worked.
Tested with a stick of 4gb kingston furyX that I had.
Tried to connect to the TV through HDMI (random suggestion from a post), tried to remove the reset button from the system panel(random suggestion from some post).
Tried a different RAM slot.
Tried to reset CMOS by circuiting, removed the battery and put it back.
Tightened the cpu cooler screws, loosened the cpu cooler screws(both were suggested).
Please, if anyone knows what's wrong / has some suggestions, leave a comment.
P.S. The stock cooler needed some force for the screws to get in place, Not sure if I did something wrong or it is supposed to be a tight fit. Also, the previous system I built was with an intel pentium, asus b250-plus, same GPU and it would not get signal from the gpu until I installed windows and latest drivers (kinda weird but yeah)
**EDIT**
I've now gotten a buzzer, which only does 1 short beep after the pc turns off and on again.
Removing the ram, and trying to start without it does no beep but no turning off and on either. Without any ram all the fans start spinning (cpu cooler led is off) and it just keeps going like this, It does not restart itself.
Facebook
Twitter
Instagram