I need help
I have elite 800 g1 and i want to uograde psu to instal vga with power conecter
I want to replace stock one 320w with huntkey 550w to powerd gpu .
Refere to post below :
http://www.tomshardware.co.uk/answers/id-2302723/elite-desk-800-psu.html
6 pin on board :
I conect 3x yellow 12v , 2x com " black " and 1 blue -12
4 pin cpu no change the same connector . 2 yellow , 2 black
6 pin - starter /fan power " 4pin+2empty "
The stock as below :
Green , grey , white,white
Reefer to post apove i connect
MB Green with PSU red 5v
MB Grey with PSU black "com"
White null
Also jump the green with black on psu as post tell
Result:
Fan work , green led work on Board , no signal on screen , also its powerd on since i plug the power cable like i jump it in out side case , i mean its start without pushing power button .
I test voltage of stock PSU , all lines conected correct expext the red 5v , on stock it show 3.3 , so i changed the red to orange witn output 3.3 the same result too ... Green led on board worcked without push power button and no signal
also i tray the the defult way of atx power " green with green , grey with black " didnot start at all ....
Any help ? Any info about atx to hp connector ?
Last things is there a diffirent between 12v. V1 and 12v V2 ?
I have elite 800 g1 and i want to uograde psu to instal vga with power conecter
I want to replace stock one 320w with huntkey 550w to powerd gpu .
Refere to post below :
http://www.tomshardware.co.uk/answers/id-2302723/elite-desk-800-psu.html
6 pin on board :
I conect 3x yellow 12v , 2x com " black " and 1 blue -12
4 pin cpu no change the same connector . 2 yellow , 2 black
6 pin - starter /fan power " 4pin+2empty "
The stock as below :
Green , grey , white,white
Reefer to post apove i connect
MB Green with PSU red 5v
MB Grey with PSU black "com"
White null
Also jump the green with black on psu as post tell
Result:
Fan work , green led work on Board , no signal on screen , also its powerd on since i plug the power cable like i jump it in out side case , i mean its start without pushing power button .
I test voltage of stock PSU , all lines conected correct expext the red 5v , on stock it show 3.3 , so i changed the red to orange witn output 3.3 the same result too ... Green led on board worcked without push power button and no signal
also i tray the the defult way of atx power " green with green , grey with black " didnot start at all ....
Any help ? Any info about atx to hp connector ?
Last things is there a diffirent between 12v. V1 and 12v V2 ?
Facebook
Twitter
Instagram