Let's start by getting it out in the open; I'm not at all a computer guy.
Hardware.
cpu - amd fx 4130
Mb- m5a78L-m lx3
Gfx- 1060 6gb
Rajimtek cpu cooler (not sure of the model)
Ram - 2x 4gb of ddr3
Psu - corsair vs450
So I just upgraded my gfx card to the 1060 6gb (with the three fans) from a gfx670 to play gta5 and overwatch with better graphics.
I intend to upgrade my motherboard/cpu and ram together when money allows it. But for the time being I was hoping to get a little bit more out of my cpu as it's bottlenecking my gfx card.
I tried using amd overdrive to do this. I did what seemed to be a modest 0.3 increase from 3.8 to just over 4.1 (without altering the voltage) . i ran stability tests via overdrive program and didn't have any issues my cpu ran at 41c without much fluctuation (I used speedfan to keep an eye on it)
After this I opened GTA and ran the benchmark test in the graphics settings. The results were worse than when I started. Where am I going wrong? I read a lot of people saying to use bios settings but as I have very little computer knowledge I was worried about damaging my computer or bitting off more than I can chew any help is welcome
Thanks in advance
Hardware.
cpu - amd fx 4130
Mb- m5a78L-m lx3
Gfx- 1060 6gb
Rajimtek cpu cooler (not sure of the model)
Ram - 2x 4gb of ddr3
Psu - corsair vs450
So I just upgraded my gfx card to the 1060 6gb (with the three fans) from a gfx670 to play gta5 and overwatch with better graphics.
I intend to upgrade my motherboard/cpu and ram together when money allows it. But for the time being I was hoping to get a little bit more out of my cpu as it's bottlenecking my gfx card.
I tried using amd overdrive to do this. I did what seemed to be a modest 0.3 increase from 3.8 to just over 4.1 (without altering the voltage) . i ran stability tests via overdrive program and didn't have any issues my cpu ran at 41c without much fluctuation (I used speedfan to keep an eye on it)
After this I opened GTA and ran the benchmark test in the graphics settings. The results were worse than when I started. Where am I going wrong? I read a lot of people saying to use bios settings but as I have very little computer knowledge I was worried about damaging my computer or bitting off more than I can chew any help is welcome
Thanks in advance