I just overclocked my ram on a b350m mobo by increasing the frequency, now my pc won’t boot. I can’t even get to my bios because it won’t register my mouse or keyboard. My monitor does not get any signal, the only thing thing hat happens Is my leds in my cadence light up. I have tried taking out and putting back in the ram and that hasn’t not even no worked , what’s should I do ? I have also tried taking out the cmos but I can’t figure out how to do it, what should I do?
PC won’t boot after increasing RAM frequency
- Thread starter STIHL
- Start date
There should be a BIOS reset jumper pin on the board somewhere. Look it up in the manual. Use a jumper or a screwdriver to short it and set everything to default. They should allow the system to boot up again.
TRENDING THREADS
-
-
RTX 4070 vs RX 7900 GRE faceoff: Which mainstream graphics card is better?- Started by Admin
- Replies: 56
-
Question PC (laptop) Is performing way below potential for a long time
- Started by yololife55
- Replies: 4
-
-
Question Would 32 gigs of ram really make a difference in a xeon e3 1240 v2 and gtx 970 build?- Started by jordanbuilds1
- Replies: 4
-
Question New pc build r9 7900x3d rtx 4080 super no post only ram rgb turns on- Started by Harvey Durward
- Replies: 2
-
Facebook
Twitter
Instagram