I have purchased this board S2600JF, have been trying to get it up. I have reversed the atx 12v connectors and connected to the motherboard.
I have shorted the ATX psu pins so that it gives 12v on the rails, as well connected the 5vsb to motherboard.
Once I switch on the ATX power supply, I get a stable non-blinking green light.
To start the board power sequence, I then short the FP PWR_BTN_N pin 36 as per page on this url
(hxxps://www.intel.com/content/dam/support/us/en/documents/motherboards/server/sb/g31608015_s2600jf_tps_r2_41.pdf)
And I then hear the following beeps 1-5-4-4 which according to the following page means (hxxps://www.intel.in/content/www/in/en/support/articles/000006001/server-products.html) means
Followed by an amber light which is constant and not blinking and nothing turns up on the VGA screen. Any ideas what else to do to get this monster up?
Here are the pictures.
I have shorted the ATX psu pins so that it gives 12v on the rails, as well connected the 5vsb to motherboard.
Once I switch on the ATX power supply, I get a stable non-blinking green light.
To start the board power sequence, I then short the FP PWR_BTN_N pin 36 as per page on this url
(hxxps://www.intel.com/content/dam/support/us/en/documents/motherboards/server/sb/g31608015_s2600jf_tps_r2_41.pdf)
And I then hear the following beeps 1-5-4-4 which according to the following page means (hxxps://www.intel.in/content/www/in/en/support/articles/000006001/server-products.html) means
Power control fault Power good assertion timeout - Power unit sensors report soft power control failure offset.
Followed by an amber light which is constant and not blinking and nothing turns up on the VGA screen. Any ideas what else to do to get this monster up?
Here are the pictures.