Hello, I am running a cat6 Ethernet cable about 80 ft from my modem and router down to my NVR with 6 cameras at 1080p and to my smart dvd player. My question is can I split the cable at the end so that 4 wires go to each, so basically they can both run off of one Ethernet cable. Will that work or does the NVR require more than 4 wires or something? Thank you for any help!
Ethernet cable question
- Thread starter samlavite
- Start date
All ethernet is point to point with a single device on each end. You can not just build some cable and make this work. You can though put a inexpensive switch at the remote end. I would recommend one that has gigabit ports but 1080p security cameras send compressed data streams so 10/100 would likely be enough. There is not a lot of extra cost to go to gigabit so I would still recommend that over 10/100
TRENDING THREADS
-
-
-
-
Question Display no signal when 1440P or higher full screen gaming- Started by Wouter_U
- Replies: 3
-
Question Download speed is slow on only my PC - please help!- Started by Ograsmium
- Replies: 9
Facebook
Twitter
Instagram