Hi folks, this is my first post on this site and I'm looking for a little advice. I recently installed the EK A240g loop in my system and with this being my first loop of this kind I just wanted to bring up some concerns I have. I may just be over thinking this but I want to be sure.
1) My pump is making a little noise. Its not very loud and when I look up other topics asking the same question it's usually because the pump is very loud with the solution either being air in the pump or it's faulty. However I am not sure what the acceptable noise level should be if there should be any at all. It's only really audible when you are right next to it.
http://
2) I have some air bubbles sticking to the side of the reservoir. I often see people saying it will go away after a while or give the case a little shake. Well I have tilted and nudged the case quite a bit at this point. I no longer see any large bubbles coming from the radiator or any of the blocks. Should I give it more time or am I missing something? Side note the tubing looks pretty clear. I don't see any bubbles in the tubing. The pump has been running for about 2 hours now for the leak test.
I would really appreciate any advice about this topic. Sorry if this is in the wrong section. I would like to end by saying thank you to this community. I have been visiting this site for years any time I had an issue come up and found an answer in another persons post that has saved me a lot of stress and money. I really do appreciate all the advice you folks have posted over the years.
1) My pump is making a little noise. Its not very loud and when I look up other topics asking the same question it's usually because the pump is very loud with the solution either being air in the pump or it's faulty. However I am not sure what the acceptable noise level should be if there should be any at all. It's only really audible when you are right next to it.
http://
2) I have some air bubbles sticking to the side of the reservoir. I often see people saying it will go away after a while or give the case a little shake. Well I have tilted and nudged the case quite a bit at this point. I no longer see any large bubbles coming from the radiator or any of the blocks. Should I give it more time or am I missing something? Side note the tubing looks pretty clear. I don't see any bubbles in the tubing. The pump has been running for about 2 hours now for the leak test.
I would really appreciate any advice about this topic. Sorry if this is in the wrong section. I would like to end by saying thank you to this community. I have been visiting this site for years any time I had an issue come up and found an answer in another persons post that has saved me a lot of stress and money. I really do appreciate all the advice you folks have posted over the years.