Hi, I have an r5 1600, prime b350 board and 2x8 corsair vengeance LP 3200 memory.
I settled on getting the ram to 2800mhz as it was a bit temperamental but I want to see if I can finally get the 3200.
The problem I'm having is setting docp to 3200 will not post.
The bios reports default soc voltage as 0.85v, however I read elsewhere that 1.1 was the new default so I stick it up to 1.11 and it will now post at 2933 and 3066.
Then when I go back into bios it claims default soc voltage is 1.1 and is currently set as 1.35v. If i set this to 1.1 again it fails to post. Go back into bios and now it claims default is 0.85v and is running 0.85. DRAM voltage is at 1.4v always
When it is working it is using 1.1 as a base then adding the offset to make 1.35, but when i remove the offset it goes all the way back to 0.85.
How can I get it to actually run the soc voltage as 1.1v? It's not exactly vital but it's a pain in the ####
I settled on getting the ram to 2800mhz as it was a bit temperamental but I want to see if I can finally get the 3200.
The problem I'm having is setting docp to 3200 will not post.
The bios reports default soc voltage as 0.85v, however I read elsewhere that 1.1 was the new default so I stick it up to 1.11 and it will now post at 2933 and 3066.
Then when I go back into bios it claims default soc voltage is 1.1 and is currently set as 1.35v. If i set this to 1.1 again it fails to post. Go back into bios and now it claims default is 0.85v and is running 0.85. DRAM voltage is at 1.4v always
When it is working it is using 1.1 as a base then adding the offset to make 1.35, but when i remove the offset it goes all the way back to 0.85.
How can I get it to actually run the soc voltage as 1.1v? It's not exactly vital but it's a pain in the ####
Facebook
Twitter
Instagram