Triggers (z-axis) not working properly

Diamond_G

Honorable
May 11, 2017
27
0
10,530
Hello. I have a Trust GXT 545 controller and recently the z-axis act on their own (in the calibrarion menu it is glitching to the left) and don't stay centered
this is frustrating in games like fifa because in the settings menu it switches between tabs all the time.I tried callibrating it, resetting it and even uninstalling the device.I can't update the drivers either!
Can i at least make another binding for in-game menus in Fifa?i mean for example at the controlls page it is just switching between general,attacking and defending tabs!
Edit:before this, the joystick was glitching
Edit #2:I noticed that this is happening only with the right trigger...it glitches for a few secs then stops but is still not centered sometimes...when i use the left one everything is ok
 

Jwpanz

Honorable
The physical switch may be stuck inside the controller. It could be debris that fell in there and gummed it up or could be broken.

If it were my controller I would take it apart and and clean it and inspect for damage. But I don’t know if you’re comfortable doing that and it may void a warranty. You could also try contacting the manufacturer for advice.
 

Diamond_G

Honorable
May 11, 2017
27
0
10,530

It can't be broken because i had it for less than a month (i barely used it actually) and in the calibration menu the axis stay still until i press any of the triggers, then it glitches a tiny bit to the left
so it is a software problem i think
also maybe you know how to change menu bindings in fifa 16?
thanks for advice anyways