Hi,
the title said it pretty much, I resetted the CMOS by putting the jumper on pin 2-3 instead of 1-2, waited a few seconds put it back on 1-2 and now the computer does not boot at all. I do not have a picture on the screen, neither on DVI nor VGA. The screen stays black, it doesnt say "no signal". It worked on the computer before, I want to set up a NAS (and am almost done )
The motherboard is kinda old, it's a ASRock K10N78.
There is no external graphic card connected. Everything there is, is the Motherboard, RAM and 3 harddrives without an operating system. The system is on a USB stick.
I already tried resetting it again by just unplugging the battery for 10 minutes without success.
The fan does speed up.
I'm kind of desperate and appreciate any help!
the title said it pretty much, I resetted the CMOS by putting the jumper on pin 2-3 instead of 1-2, waited a few seconds put it back on 1-2 and now the computer does not boot at all. I do not have a picture on the screen, neither on DVI nor VGA. The screen stays black, it doesnt say "no signal". It worked on the computer before, I want to set up a NAS (and am almost done )
The motherboard is kinda old, it's a ASRock K10N78.
There is no external graphic card connected. Everything there is, is the Motherboard, RAM and 3 harddrives without an operating system. The system is on a USB stick.
I already tried resetting it again by just unplugging the battery for 10 minutes without success.
The fan does speed up.
I'm kind of desperate and appreciate any help!