Okay so my case is NZXT phantom 820, and my motherboard is Asus Formula X
Now before I say anything I would like to say "Yes I did go to the manual and read what it has to say" unfortunately it is not helping me much, specially the NZXT case manual
The motherboard comes with some black block that has all the names for the panel controls, on that block it writes: "Power and Ground", "Reset and Ground" and "HDD LED+ and HDD LED-"
My problem is, WHICH side on those switches is + and which is - ? So that I'd know how to orientate them correctly .... On each switch, there is a white wire attached to it, and a black wire on the other side
And should I use this block at all? .... Honestly it has much less confusing instructions written on it than the diagram on the motherboard's header
Thanks for any tip you could provide
Now before I say anything I would like to say "Yes I did go to the manual and read what it has to say" unfortunately it is not helping me much, specially the NZXT case manual
The motherboard comes with some black block that has all the names for the panel controls, on that block it writes: "Power and Ground", "Reset and Ground" and "HDD LED+ and HDD LED-"
My problem is, WHICH side on those switches is + and which is - ? So that I'd know how to orientate them correctly .... On each switch, there is a white wire attached to it, and a black wire on the other side
And should I use this block at all? .... Honestly it has much less confusing instructions written on it than the diagram on the motherboard's header
Thanks for any tip you could provide