Hi everyone!
I am trying to setup a RAID 0 array with two Intel 600P 128GB drives in M.2. The bios sees the drives fine, and I can create the array. But the W10 installer cannot see the drive.
I have used the driver provided on the Gigabyte website, and also the driver from the Intel RST website. Both just report that `No new device drivers were found`.
Any ideas how I can get this to work?
I am trying to setup a RAID 0 array with two Intel 600P 128GB drives in M.2. The bios sees the drives fine, and I can create the array. But the W10 installer cannot see the drive.
I have used the driver provided on the Gigabyte website, and also the driver from the Intel RST website. Both just report that `No new device drivers were found`.
Any ideas how I can get this to work?