Hi everyone,
I just built this PC a little less than a year ago and I’m having an issue with my CPU overheating.
I’m using an ASUS Maximus Hero IX for my Mobo, with an i7 7700k and a Corsair H110iv2 cooling it. Everything was fine up until a few days ago, when my PC failed to boot and I kept getting errors saying a CPU fan was registering.
I went to the BIOS where it showed my CPU temp at 89 degrees. The H110iv2 fans were spinning like crazy, loud as shit but the temperature on the CPU never dropped and started to rise. I promptly shut my PC off and haven’t touched it until today.
I’m assuming the pump on the AIO cooler went out, however I couldn’t get into the Corsair Link software to check the pump RPMs. This is my first time dealing with an AIO cpu cooler so I’m just curious as to whether I did everything right installation wise.
My mobo has a 4 pin header for an AIO Pump which I didn’t plug anything into. I plugged one of the cables into the CPU OPT header which is 4 pin, and looks like I plugged the other into a USB header.
It was almost a year ago, and I’m fairly certain I followed the Corsair instructions but I’m not certain.
What does it sound like to you? Pump failure?
I just built this PC a little less than a year ago and I’m having an issue with my CPU overheating.
I’m using an ASUS Maximus Hero IX for my Mobo, with an i7 7700k and a Corsair H110iv2 cooling it. Everything was fine up until a few days ago, when my PC failed to boot and I kept getting errors saying a CPU fan was registering.
I went to the BIOS where it showed my CPU temp at 89 degrees. The H110iv2 fans were spinning like crazy, loud as shit but the temperature on the CPU never dropped and started to rise. I promptly shut my PC off and haven’t touched it until today.
I’m assuming the pump on the AIO cooler went out, however I couldn’t get into the Corsair Link software to check the pump RPMs. This is my first time dealing with an AIO cpu cooler so I’m just curious as to whether I did everything right installation wise.
My mobo has a 4 pin header for an AIO Pump which I didn’t plug anything into. I plugged one of the cables into the CPU OPT header which is 4 pin, and looks like I plugged the other into a USB header.
It was almost a year ago, and I’m fairly certain I followed the Corsair instructions but I’m not certain.
What does it sound like to you? Pump failure?