- May 16, 2018
- 3
- 0
- 10
After the CMOS battery change ( I waited over 5 mins) the PC would not start. What it does do is, when I
turn the power supply back on, the pc immediately starts, then shuts back down in about 5 seconds. Pressing the power button does nothing. So if I shut the power supply off again, wait until all power is out of system then turn supply back on, it will start up, then shut down.
I checked all connections, and can't figure it out.
This system was running fine just prior.
Thanks, Bob
turn the power supply back on, the pc immediately starts, then shuts back down in about 5 seconds. Pressing the power button does nothing. So if I shut the power supply off again, wait until all power is out of system then turn supply back on, it will start up, then shut down.
I checked all connections, and can't figure it out.
This system was running fine just prior.
Thanks, Bob
Facebook
Twitter
Instagram