Question [solved] Cannot connect to Hitron CDE-30364 router

Hi forum.

Have two old computers runing Linux that have wifi.

Computer 1, Laptop:
Thosiba Satelite, SA50-111, PSA50E-06W03PNO
OS: Linux Mint 18.3, 32 bit

Computer 2, midi tower with MB/CPU from 2003'ish (AMD Athlon 3200)
PCI Wifi card: Ralink corp. RT2561/RT61 802.11g PCI
OS: BunsenLabs "bl-Helium_i386_cdsized+build2.iso"

For both computers, the connection issue appear similar, and both computers have earlier being able to connect to the router successfully.
That is - both computers have a history of successfull wifi connections both when running XP (before it was abandoned) and various linux distros, so I find it very unlikely that bad wifi cards is the cause of this problems.

Problem description: Both computers is able to find the name of the ssid. When I try to connect to wifi, a password prompt, I type the password and it seemingly going busy a couple of seconds trying to connect. But instead, the password prompt just reappear again.
Even if I try to connect several times using the correct password, the password prompt just goes in an never ending loop.

Details about router:
Vendor identification Hitron Technologies
Model Name CDE-30364
DOCSIS mode DOCSIS 3.0
HW version 1A
SW version 3.1.1.35-HEG
Boot rom version PSPU-Boot 1.0.16.22-H2.8.11

Wireless ON/OFF "Enable"
Wireless Mode "11B/G/N mixed"
Channel Mode "EURO"
Channel "Auto"
Current Channel "13"
Channel BandWidth "20/40MHz"
Run WPS [PCB] [PIN]
WPS Current Status "Not used"
SSID setting
  • hidden "no"
  • in-service "yes"
  • WMM Mode "no"

Security Mode "WPA-Personal"
WPA Mode "Auto (WPA-PSK or WPA2-PSK)"
Cipher type "AES"
Group Key Update Interval "3600" (seconds)
Pre-shared Key [not sharing my password just like that]
Pre-Authentication "Disable"

MAC Filtering Mode "Allow All"
Auto-Learned Wireless Devices [there is a list that contains 2 devices - there are at least 4 devices in the house that I know can successfully connect to the wifi and get internet access]
 
Last edited:
Have a update, but sadly the real world solution doesn't give a properly detailed description on how to solve the issue. Technically it is solved since both computers now iare online, using their WiFi card.

Computer 1, Linux Mint 18.3:
Ran it for about one week using cat5 cable. Somewhere between, I did a full Linux Mint update. The cable was crossing the living room, so I used to coil it up before night. But even avter a full OS update, the WiFi did still did not work (same behaviour as before, nothing changed)
Ok so suddenly a day (a week later) when I was turning the computer on and did some browsing on the web, I realized that the cat5 cable wasn't there - The issue had solved itself kind of.

Computer 2, Bunsenlabs Linux
Did a full OS update while connecting to cat5 cable. After a reboot, the WiFi suddenly worked.


Therefore: For computer 1 I have found no solid recipe to solve the WiFi issue. Nor do I know why the WiFI suddenly decided to work again.
And for computer 1, the issue was solved by a full OS update while connected by wire.
 
Short update.

Computer 2 have not being in use for a while. I have installed a cat5b cable to that spot anyway so the new computer would have cabled network.

Computer 1: The wifi card have turn worse, and I can't get it to connect any more. I have come to the conclusion that It is probably physically defective.
I have another laptop running Linux Lite that I have shared the network connection, so the old Thosiba computer now have internet through a cross coupled cat5 cable.

None of the other computers on the same network have similar problems. And therefore I consider the whole case as solved.