i just upgraded my fx6300 to a ryzen 5 2600, rog strix b350f motherboard, patriot viper(PVE48G266C6GY). i also have a 650w gold psu and the cpu is on a custom loop. i had 400 dollers to do this upgrade with 0 wiggle room so i went mid range preformance. i have some exp. in ocing and was able to get the cpu to 4.2ghz @ 1.28125 (and from what ive read/seen that is pretty good v for 4.2?) but when i enable d.o.c.p to get the ram to the 2666 its supposed to run at i fails to boot. the docp is set to 16-17-17-36 @1.2 ive also tried entering it manually in ryzen master also. and for the life of me i cant get it to stick. looking for any advice/help i can get. love this stuff and wanna learn as much as possible
new r5 2600
- Thread starter h3n0420
- Start date
ive tried going to 1.32 with no results. the best ive been able to do is up it to 2400mhz @ 14-15-15-34. i believe this stick of ram is mislabled. on the web site i bought if from it says 2666 @ 16-18-18-36 1.2v but the docp reads 16-17-17-36 and ive tried putting in the advertised timings with out it working
CountMike
Titan
- Oct 31, 2015
- 33,771
- 3,150
- 147,990
Grab this program: http://www.softnology.biz/files.html
Under EPROM > Read SPD..... will tell you which exact memory you have.
Under EPROM > Read SPD..... will tell you which exact memory you have.
TRENDING THREADS
-
-
Question Intel SSD 320 series fried diode (?) CR3, one contact, should I remove it?
- Started by kornsoud
- Replies: 7
-
-
-
-
Question Can I just upgrade my graphics card or should I be upgrading my processor as well for UE5?- Started by Tolstoy1990
- Replies: 6
-
Latest posts
-
-
Question Microsoft Defender found Trojans on my PC- Latest: Tommy Sawyer
-
-
-
Facebook
Twitter
Instagram