So for my first water cooling build, I tried using some pass through valves and ended up drilling about an inch diameter hole on the hard drive rack in my case.
Anyway, due to inexperience, I realized my initial layout was not ideal and I have devised a much better and easier water cooling layout. But as a result, I moved my reservoir and drilled a new pass through hole. So does anyway have a good way to cover my old holes in the case, or at least make them a little less noticeable. I'm thinking maybe laser cutting a very thin piece of acrylic or maybe even some metal putty, but that could get messy. Any suggestions or past experiences would be very helpful!
Anyway, due to inexperience, I realized my initial layout was not ideal and I have devised a much better and easier water cooling layout. But as a result, I moved my reservoir and drilled a new pass through hole. So does anyway have a good way to cover my old holes in the case, or at least make them a little less noticeable. I'm thinking maybe laser cutting a very thin piece of acrylic or maybe even some metal putty, but that could get messy. Any suggestions or past experiences would be very helpful!
Facebook
Twitter
Instagram