-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
Speaker Ohm issue
- Thread starter imdylanr
- Start date
Solution
imdylanr :
Rogue Leader :
Yes, wire them in parallel, that will half the load.
If I wire both pairs of speakers in parallel and solder them both to the output jack would that change the impedance?
If you only have one input to the speakers from your amp and 4 total 8 ohm speakers there is no way to make a 4 ohm total load with those speakers.
You cannot connect both pairs in to 1 connector and get 4 ohms. The best you could do is wire them in series parallel and get an 8 ohm load. If you wired them all in parallel it would be 2ohms.
- Dec 22, 2014
- 32,765
- 2,832
- 113,640
- Dec 22, 2014
- 32,765
- 2,832
- 113,640
imdylanr :
Rogue Leader :
Yes, wire them in parallel, that will half the load.
If I wire both pairs of speakers in parallel and solder them both to the output jack would that change the impedance?
If you only have one input to the speakers from your amp and 4 total 8 ohm speakers there is no way to make a 4 ohm total load with those speakers.
You cannot connect both pairs in to 1 connector and get 4 ohms. The best you could do is wire them in series parallel and get an 8 ohm load. If you wired them all in parallel it would be 2ohms.
- Status
TRENDING THREADS
-
-
-
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session- Started by Admin
- Replies: 58
Facebook
Twitter
Instagram