Ok so my case is a Silverstone PM01 and in the top of the case is a spot for a water cooler. I had a normal air cooled system in this case for a while and I just bought an AIO (specifically corsair H100i v2) and I tried putting the radiator in the top section but noticed there was nowhere to put the big fat tube, it's all just honeycomb meshing. Am I meant to cut into it? I tried just putting the radiator inside and putting the fans up there for a pull configuration but the connector for the fans doesn't fit through the holes into the case (there are a few long holes that is for putting the screws through, the cable might be able to fit if I trimmed the plastic on the connector but I shouldn't have to do that).
So if there something I'm missing or am I meant to cut into my case?
So if there something I'm missing or am I meant to cut into my case?