[SOLVED] Temps on 2600

xravenxdota

Reputable
Aug 26, 2017
435
66
4,990
Hi i want to know what would be a good temp for my new rg.

System spec

Cpu:2600 non X clocked to 4100mhz
Mobo:MSI B450 gaming plus atx
Ram:2x8gb crucial ballistic 2666mhz clocked to 2933mhz
CPU cooler: Cooler Master MasterLiquid ML240L RGB
Case:Coolermaster MB500.

I have been playing around with her first on stock cooler but even on stock frequency she would go up to 82c when gaming so changed to an watercooler(First time that i have one)So i oced her to 4.1ghz and when running cinebench the cpu goes up to 67c.Now what would be a save temp for this cpu?I want to try and go for a 4.2ghz oc but kinda scared as i am more accustomed to the older hardware :D.My volts are at 1.375v.What would also be a save volt for this chip.Pretty sure i read somewhere not over 1.4v
 
Solution
you could go for 4.2 ghz... set the voltage to auto... run your benchmarking software... have cpu-z running whilst to read the voltage running the 4.2 ghz benchmark. Use this as a baseline and deacrease 0.05volts in increments... 67 is a perfectly safe temp.

BringerOfTea

Reputable
you could go for 4.2 ghz... set the voltage to auto... run your benchmarking software... have cpu-z running whilst to read the voltage running the 4.2 ghz benchmark. Use this as a baseline and deacrease 0.05volts in increments... 67 is a perfectly safe temp.
 
Solution

xravenxdota

Reputable
Aug 26, 2017
435
66
4,990
Ok i got it stable on 4.2ghz.I did leave voltage on Auto but it was pushing the cpu voltage to 1.464v and would crash after 3/4 cinebench runs.So i changed the voltage manually to 1.4v and it runs stable but i am running her on 4.1ghz for everyday use