abit ip35 pro wie kann ich sata-raid installieren?

hallo leute,

ich habe mir ein abit ip35 pro bestellt und lese gerade durch die bedienungsanleitung ftp://ftp.abitshop.com/pub//manua [...] 35-pro.zip auf seite 56 um zu verstehen wie ich raid1 über 2 x sata aktivieren kann.

lese ich richtig, dass ich für die installation ein 3,5 zoll laufwerk benötige?

danke für euren support

thomas



Bedienungsanleitung:
3.10 SATA RAID Driver (for Windows XP, 2003, or 2000)
The “Driver Disk Maker” program bundled in the Driver-&-Utility CD is a utility to build the driver
program needed for SATA controller into a floppy disk under DOS environment. This procedure
is necessary only for installing Windows operating System to the hard disk connected to
“eSATA1” or “SATA1~SATA6” connector.
To create a driver disk:
1. Before starting, connect a 3.5” floppy disk drive to the “FDC1” connector, and connect a
CD-ROM drive to your motherboard. Prepare a 3.5” floppy disk.
2. After completing all the start-up preparation for hardware setup, power on the System.
3. Enter the BIOS Setup Menu by hitting <Del> key1.
Enter and select the BIOS menu “Advanced BIOS Features”. Configure the option
“First Boot Device” to “CD-ROM”2 drive. Save this selection and exit BIOS setup menu
by accessing the BIOS menu “Save & Exit Setup”.
4. Restart the System. The System will now boot from CD, and enter the ABIT Boot Manager,
the following options appear3:
(0) Boot From First HDD
(1) Make Driver Disk
(2) Boot From First Floppy Drive
(3) Skip CD-ROM Boot (Try Next Boot Device)
Type <1> and hit <Enter> key. The following options appear:
(1) Make Driver Disk
(2) Exit
Type <1> and hit <Enter> key to start making.
5. The driver options appear:
(1) Intel SATA RAID Driver Disk for WinXP_2K_2003_Vista
(2) JMicron SATA RAID Driver Disk for WinXP_2K_2003_Vista
Type the number of the actions you want and hit <Enter> key.
6. Insert floppy disk to the floppy drive4. Press any key to continue.
7. Copying files to floppy now starts. After completed copying, hit the <n> key if you do not
want to make another Driver Disk, and stop at the A:\> prompt.
8. Take out the Driver-&-Utility CD from the CD-ROM drive now. Restart your system5.
1 You may refer to the chapter “BIOS Setup Menu” in user’s manual on how to do so.
2 The name may vary as per BIOS version. Place the “Driver-&-Utility CD” into the CD-ROM drive now.
3 You will have to type your command within 20 seconds, or the System will boot from HD.
4 You will be asked to do the format procedure if the floppy disk is not blank. Hit <n> key for not formatting
another floppy.
5 Now you have this driver disk ready for installing Windows Operating System. Insert this floppy disk to
floppy drive and press <F6> key when the screen instruction prompts you to install a third-party SCSI or
RAID driver.