The NEW best nForce2 board!

[TheRod]

The new DFI NFII Ultra - Lan Party seems to offer the bast performance and overclockability for nForce2 based MB...

Read this review :
<A HREF="http://www.anandtech.com/mb/showdoc.html?i=1840" target="_new">http://www.anandtech.com/mb/showdoc.html?i=1840</A>

--
Would you buy a GPS enabled soap bar?

 

[pIII_Man]

thanx for the link...looks like dfi knows a thing or two about mobos...

The only bad thing is it does not have the mounting holes around the socket :frown:

3 386DX-25's...12 volts...glue some ln2 and a wicked amount of overclocking and you get a willamantee minus 36 pins, 33.75 million transistors and a couple hundred mhz...

 

[TheRod]

But, I think that many good heatsinks that fits on the socket can do the job a cooling an overclocked Barton.

I wish to know how much more OC you can do with a massive heatsink. I'm not sure you get lots of improvement over good a "socket-friendly" heatsinks.

I would like to see the OC numbers for these cooling solutions :
BOXED heatsink
Good heatsink
hole-mounted heatsink
Watercooling
"Antartica" cooling...

This would make a good THG article/review of different solutions!

--
Would you buy a GPS enabled soap bar?

 

[pIII_Man]

sure would...possibly in latter revisions they will add the mounting holes just as with many early boards that lacked them...

3 386DX-25's...12 volts...glue some ln2 and a wicked amount of overclocking and you get a willamantee minus 36 pins, 33.75 million transistors and a couple hundred mhz...