Werfault exe start up error

Have you installed any new software/hardware recently? Specifically, anything from Logitech?

You can opt to turn the feature on or off here depending on your preference. If you want to use the feature, you can customize it according to your requirements.

Go to Windows Error Reporting, open Control Panel.

Click System and Maintenance, and then click Problem Reports and Solutions.

Click Change Settings located in the left panel of the Problem Reports and Solutions window.

Select an option to configure how you want Windows to look for a solution to your problems. You may allow Windows to do it automatically or ask you every time to check if problem occurs.

Next, click the Advanced settings link.

Select On or Off to configure whether you want to use Error Reporting or not.

Click Change settings and choose the appropriate option to configure how you want problem reporting to be set for all users and programs.

If you choose to use Error Reporting, then click the second Change setting button to configure how error reporting is set for all users. Here, you can choose from the following consent levels:

Ask each time a problem occurs – Windows Error Reporting will ask for permission before sending an error report

Automatically check for solutions – Minimal data is sent to find a possible fix. After consent is given, more data may be sent if requested by Microsoft.

Automatically check for solutions and send additional information if needed – Minimal data along with data that the application developer has indicated as a requirement is sent. This sent data does not contain any personally identifiable information. After consent is given, more data may be supplied if requested by Microsoft.

Send all data - All data is sent, no prompt required. This setting is configurable only in Group Policy.

If you do not want certain executable files or programs to send error reports, you may create a block list. To do this, click Add in the Block list section.

Browse through your programs and add them to the list.

Click OK to save your settings.

- Jake

Windows Outreach Team

thanks for the reply however the pc will not boot to windows at all ,i dont even get a safe mode option to add to this the image that i used on this pc to restore it also was used on a pc that is working fine (yes same model of pc using the acronis image ) I ran diagnostics on the pc hd amd mem test could and if so what kind of hard ware issue am i dealing with . thanks again !!

Did you get an answer to this? I cannot start my computer, I get the WeFault.exe error before anything shows up, so i have no way to get to the control panel and adjust any settings. Help!

Open a new thread on your problem, that is the best way to get helped : )

This post is 15mo. old.

This topic has been closed by Nikorr.