Wireless Bridge 2 networks

Archived from groups: alt.internet.wireless (More info?)

Good Evening:

Here's my dillema:

Network #1:
5 workstation network connected to Linksys wired router connected to modem
connected to DSL. Router is 192.168.1.1 Life is good.

Network #2:
3 workstation network connected to DI-524 wireless router. Router is
192.168.1.2 Life is good.

Added D-Link bridge and JUMBO antennae on network#1 to link 1 & 2 together.
Life is still good!

#1 can access all computers on both networks AND www. #2 can access all
computers on network but NO www. I believe it is a port setting on one of
the routers. Which router and what ports should I open?

Any ideas would be most helpful.

Thanks,

Scott

All

Archived from groups: alt.internet.wireless (More info?)

D-Link Bridge: DWL-G810
Linksys Router: befsr81 (DSL Enabled)
D-Link DI524 WAN port is EMPTY.

Thanks in advance.


"Jeff Liebermann" <jeffl@comix.santa-cruz.ca.us> wrote in message
news:8r33p0pmfr3ia5hkcr0tlh1alhj6asfboi@4ax.com...
> On Tue, 9 Nov 2004 20:48:10 -0600, "me" <me@spamnet.net> wrote:
>
>>Network #1:
>>5 workstation network connected to Linksys wired router connected to modem
>>connected to DSL. Router is 192.168.1.1 Life is good.
>
> What model Linksys wired router?
>
>>Network #2:
>>3 workstation network connected to DI-524 wireless router. Router is
>>192.168.1.2 Life is good.
>
> Where does the WAN port on the DI-524 go to?
>
>>Added D-Link bridge and JUMBO antennae on network#1 to link 1 & 2
>>together.
>>Life is still good!
>
> What model D-Link wireless bridge(s)?
>
>>#1 can access all computers on both networks AND www. #2 can access all
>>computers on network but NO www. I believe it is a port setting on one of
>>the routers. Which router and what ports should I open?
>
> Naw. Your default route on the network #2 workstations has to point
> to router #1 (192.168.1.1). My guess(tm), is that you still have the
> DHCP server in the DI-524 running on Network #2. It's giving bogus
> gateway addresses to the workstations on Network #2.
>
> I suggest you remove the DI-524 completely. Use the unspecified model
> D-Link trasnparent bridge(s) as they were intended to be used. Since
> it's a bridge, not a router, the bridges know NOTHING about IP
> addresses and such. Just make sure that broadcast traffic is enabled
> to pass across the bridge. If not, then the computahs on Network #2
> cannot get IP addresses from the unspecified model Linksys router DHCP
> server on Network #1.
>
>
> --
> Jeff Liebermann jeffl@comix.santa-cruz.ca.us
> 150 Felker St #D http://www.LearnByDestroying.com
> Santa Cruz CA 95060 AE6KS 831-336-2558