Need ABIT KT7 beep codes

[Guest]

Anyone know where these can be found? They're not in the manual. I'm getting one long beep followed by 2 short beeps. What the devil is wrong.

 

[Guest]

Taken from the "Troubleshooting" section of the KT7 FAQ at:

<A HREF="http://go.to/kt7faq" target="_new">http://go.to/kt7faq</A>

<b>When I try to boot my motherboard beeps at me. What does this mean?
There are a number of beep code you may experience:

No beep at all - this means your motherboard is dead, either due to a defective or underpowered power supply, poorly seated CPU or RAM, or a dead-on-arrival board
One beep - board is working fine
Beeeeeep-beep-beep - this means no video card detected (or poorly seated video card)
A single tone, repeated over and over. This is a memory problem (could be the DIMM, the controller, or the CPU cache memory).
A two-tone siren, generally caused by overheating or out of specification voltages.
Rapid stream of beeps - this means a key is stuck on your keyboard, it is not properly plugged in, or the keyboard is incompatible in some way
The AWARD BIOS offers no other codes - any other error messages are displayed on the screen</b>

 

[Guest]

Thank you. I had found this site but missed the section you quoted. Too bad it's not in the manual

 

[BlackWyvern3]

I have no beeps at all but my motherboard works perfectly

 

[jg38141]

you probobly didn't hook up the internal speaker to your motherboard correctly then. Not that it matters, but if you did it would give one start up beep. Remember when you could run games off your internal speaker? long long ago.

"Are you saying that I can dodge bullets?"