I saw that Tom didn't approve of this board too much either, But so far I gotten Soundcards, UDMA hard drives (33M/s) and both a voodoo blaster Banshee, and a Viper V770D Ultra Video card to work on it. I have had problems with the bus settings of 112, and 124 though. Another problem was the board never getting through the windows startup, and resetting before the login screen. It was on windows 98SE, but I think that was due to a bad overlay install. The FIC site says that K6-IIIs work on revision 2.1, however I was planning on using a K6-III+ which uses a 2.0 core voltage, but a 3.3 I/O voltage, I didn't know if this board supported it. Thanks for the help though. I might go look for a new board.