checking NVRRAM

[Guest]

Hi
I just installed a new pentium processor (pII 300).
Power on and a got the message "checking NVRAM" 'none volatile ram'.
Then the system hangs. It's during his POST that he gives it.

Any idea, personnaly i think its the L2cache or broke the entire proc.

 

[Guest]

This is mayby a solution :

There are also reports of other configurations causing static resource conflict warnings. Some of these instances appear to be corrected by clearing the ESCD area in NVRAM. This can be done by performing a CMOS clear:

Note your current settings
Turn power off
Set the CMOS Clear jumper or switch to the CLEAR position (see the product documentation)
Turn power on
After approximately 30 seconds turn the power off
Set the CMOS Clear jumper or switch to the OFF or NORMAL position
Turn your system on and enter the CMOS setup to change settings as you require (hard drive, etc.)