HeatSink

[Guest]

I have a P3V4X and I want to cool the clock generator.

Where can I get a thermal glue?
I cant think of any way to attach this thing without a glue or epoxy.
What do other people do to get this thing to stay on?


I say Prove it!

 

[BigRat]

try coolerguys.com they have it but i don't buy online so i'm not sure if they are reliable

:redface: :frown: :lol: :tongue:

 

[Crashman]

Use JB Weld. It works wonders. I use it on video cards all the time. It is a very good heat conductor. Just be carefull-it gets messy. Put a small dab on the chip, spread it into a thin coating, then apply the heatsink. It will cure in a few hours. Or you can heat it to make it cure in as little as 10 minutes.

Cast not thine pearls before the swine

 

[Guest]

thank you for your time and I appreciate your help.


I say Prove it!

 

[CALV]

Im not sure about jbweld, some people say its fine, others disagree, I've never used it so wont comment. www.theoverclockingstore.co.uk sell arctic silver epoxy, Im not sure weather they will post overseas though, but most overclocking type sites should have it, I've used it and its good- costs more than jbweld too


Next time you wave - use all your fingers