can i overclock? this board

[Guest]

I bought a cp chips m810 lmr motherboard on board sound,vid,56k,lan. using a duron 750 i think i unlocked the l1 and adjusted the l3,l7 bridges but i cant seem to adjust the speed in the bios . the 2 choices are 750mhz @100fsb, or 1000mhz at 133fsb 1000 but 1000 wont work. i shorted out the bridges 3 volt battery and pins to open up the conection mechanical pencil to close the outhers??@! any ideas would be great thanks

 

[Crashman]

You may have to raise the core voltage of your procesor. If this is not available in BIOS, it's time for more pencil tricks.

Cast not thine pearls before the swine

 

[girish]

it seems your motherboard is not oc friendly. so you dont have much choice for FSB adjustments, apart from 100, 133 and of course, zero

you could set your FSB to 133, and lower the multiplier to say 6.5, to run the processor at 866 MHz. this should be the optimum value for the given board and cooling conditions.

you might again need to work with the L7 bridges to get the core voltage right. the current value of 1.65V should be okay, but you might need to increase it by 0.025V (next step) if you notice any unstability.

girish

<font color=blue>die-hard fans don't have heat-sinks!</font color=blue>