Chipset Fan

Forum Motherboards & Memory : General Motherboard - Chipset Fan

Tom's Hardware: Over 1.4 million members in 6 different countries available to answer all your high-tech questions. Sign up now! Its free!
Word :    Username :           
 

I have just built my new pc about the first week of Oct. I have a Shuttle AK31v2, Athlon 1.4G,512MB PC2100 DDR. Shortly after I first started my system I noticed a humming, buzzing sound, about 30 seconds apart, lasting 2-3 seconds, then it stopped. Here lately it has started up again, and seems to be more frequent, I thought it was my hard drive at first, even though it is only 1 yr old, but I discovered the other day it is the fan mounted over the chipset. What could be causing this, and can I stop it? It is somewhat annoying, but I also worry about it causing some harm to my system. Also I noticed 2 spring loaded buttons located diagonally from each other on either side of the fan, what are these? Thanks for any help...

Sponsored Links
Register or log in to remove.

The spring loaded buttons could be the mechanisn that holds the chipset fan onto the motherboard! Just give them a firm press down as they may not be clipped into the motherboard correctly and thus may cause 'vibration', hence the 'humming/buzzing' you are hearing!

It could also be due to a poor/faulty fan!! If it is not Out Of Warranty, send an e-mail to the boards manufacturer and see if they have a returns policy on the fan as a replacement may be needed!

Reply to GokuFurinji

i have this pb with my new cooling fan for 1 wks or 2

& i ask me, this fan is some [-peep-] !

but after this period, no still buzzy sound, the fan was quiet, but the sound originate from the blades & the electric engine, not the springs

i think it sound just because it was new & you have to wait for an adaptation period

maybe it's also your case

EasyInfo :cool:
I would like to Invest for my PC !!
ok, buy nothing.

Reply to labdog

Hmmm, such short periods of ocillation are normally caused by resonence, which would indicate something loose. Check the fan to see if it moves on the sink, the sink to the northbrige, and the fan blades to the fan housing (bearing play). If it's bad bearings, you have a legit gripe for replacement, anything else that's loose can be tightened.

What's the frequency, Kenneth?

Reply to Crashman

I had the exact same problem with my A7V133. The problem developed after about a week of operation. According to Asus, this was a common defect with that board, and they sent me a replacement fan. That worked fine for about 8 months, then the same problem developed. I'm beginning to think it's a design defect in the fan (Asus sent me two more, a replacement and a spare, which I have yet to install). Anyway, the problem for me was the fan itself (possibly a bad bearing). The problem was definitely heat-related: once the system "warmed up" for 20-30 seconds, the problem was gone, and even a full shutdown/restart would not show the problem unless the system was left off for several hours.

Reply to dmcmahon
Tom's Hardware > Forum > Motherboards & Memory > General Motherboard > Chipset Fan
Go to:

There are 1141 identified and unidentified users. To see the list of identified users, Click here.

Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
They won a badge
Join us in greeting them