BX6 "unworkable" 600B

[Guest]

Running a 600B FSB133 pentIII on a BX6 with the following settings according to tom's chart:

CPU operating speed(PCI) - 133(1/4)
Multiplier Factor - x4.5
SEL100/66# Signal - High
AGPCLK / CPUCLK - 2/3
Speed Error Hold - Enabled
Core Voltage - 2.05v

But everytime it boots up I get "CPU has changed or is unworkable"...

Any way around this? Or am I going to run into a problem with CPU? (so far I've loaded windows 2000 and seems to run...)

 

[camieabz]

Try loading up the Default BIOS and start again. Maybe a couple of things. With the AGP at 2/3 of 133 = 89MHz. What gfx card are you using?

<b><font color=blue>~scribble~</font color=blue></b> <A HREF="http://www.ud.com/home.htm" target="_new">Help cure cancer.</A>

 

[Olfin_Bedwere]

If you've no qualms with the overclocked AGP bus, just disable the Speed Error Hold, and it'll boot fine.

 

[Crashman]

It's that Speed Hold Error thing-turn it off!

What's the frequency, Kenneth?