P4 2.8 800fsb
1 gig (4 x 256) Crucial 3200 DDR
ATI x800XT 256 Video Card
Ultra X-Connect 500w Power Supply
Ok.. so here's the issue. I just bought the power supply to get rid of a poor one I have now. There is an issue with a connector though. That 4 pin atx connector (I always call it the P4 connector) will not fit on my board. The socket for it (square one) is lodged in between a capaciter and my memory banks. There isn't enough room to get this fat plug on it.
Anyone run into this problem? Anyone have a solution for this problem other then buy a new motherboard or get a different power supply? Is there anything I can do to get this thing on there?
Thank you in advance for your help. I greatly appreciate it.
Are you sure you have it in the proper orientation? Is it the clip that's interfering?
<font color=blue>Only a place as big as the internet could be home to a hero as big as Crashman!</font color=blue>
<font color=red>Only a place as big as the internet could be home to an ego as large as Crashman's!</font color=red>