I want to write low-level software from the ground up to run my PC as my current operating system is inadiquate for almost everything.Can anyone provide me with some info?
Here is as much of my systems specification as I could get hold of:
MBC ROMA:
-------------------
Mainboard:Micro-Star
MS-5169
ATX AL9 Mainboard
socket 7
Aladdin 5 chipset
1 AGP, 4 32BIT MASTER PCI BUS SLOTS
3 16-BIT ISA BUS SLOTS,2 SERIAL,PARALLEL 2USB
CPU:AMD K6-2 3D now!
Memory:64MB 100MHz SDRAM
PSU: Sky Hawk Switching ATX PSU
Model: SH250AB
Graphics:8MBATI XPERT 98 3D AGP
HDD: SEAGATE MEDALIST 4321
MODEL ST34321A
ULTRA DMA/33?
4GB
Floppy : 3.5" 1.44 MB
Sound cardrinted on pcb:-
GENIUS 36XCD
FCC ID:FSUG7047
K0237047 REV:B
Printed on chip on card:
CRYSTAL
ZTARSE9833
CXA235-XQ3 EP
may be CX4235.......
Sound blaster compatible
CDROM: 36 speed IDE/ATAPI
Monitorlug & Play 15"non interlace .
meets the EPA energy star,VESA DPMS &
NUTEK - TCO 1992 spec
Specification
CRT 15" F.S.T., noneglare, 0.28 dot pitch
RESOLUTION: 1024 X &768 max
INPUT/ VIDEO SYNC: Analog : 0.7 Vp-p,75 Ohm,RGB(+)
Separate: TTL level (+) or (-)
Horizontal: 30 - 57 kHz
Vertical : 47 - 120 Hz
POWER: 100-240V-AC, 60/50 Hz,1.5A(max)
Degaussing: line operated automatically
Consumption : 90W max
OPERATING: Temperature:32 F to 104 F /0 C to 40 C
Humidity :10% to 95% R.H.
Altitude: 0 to 10,000 ft
LOW RADIATION: MPR II (standard) /TCO '92(Option)
PLUG & PLAY: VESA DDC(Display data channel): 1/2B
VIDEO CABLE: 15 pin D-type male conector
DB-15 pin out
1R 2G 3B 4Gnd 5DDC,gnd 6R,gnd 7G,gnd 8B,gnd
9NC 10GNd 11Gnd 12SDA(Bi-directional data) 13H 14V
15SCL(Data Clock)
COMPATIBLITY MODES:
VGA/VESA(350,400,480 line modes) & 8514/A
VESA standard(800 X 600) 56/60/72/75/85 Hz
VESA standard(1024 X 768) 60/60 Hz
You are about to answer a thread that has been inactive for more than 6 months. If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.