100mhz FSB@133, any volt changes needed?

[kinney]

I am running my athlon c 700(bridges crossed) on a kt7a. a 5.5 multiplyer and 133mhz FSB comes to 733/133.

Only volt changes I made is I'm running 1.825 volt to core. Is this to much than needed and should I change any other power settings?

Thanks.

 

[CALV]

ideally we should run at the lowest stable voltage, therefore creating as little heat as possible. if you are 100% stable, lower the voltage, if still stable, good, if not, put the voltage back up

Next time you wave - use all your fingers

 

[girish]

if you are running your 700 at 733, then I'd say you havent overclocked it at all!

700 should work fine at around 850 with any fan, higher with better cooling. you are already working a wee-bit high at 1.825 for 733/133.

I'd suggest you reduce the voltage to 1.775V (higher by 0.025V over default) and set the multiplier to 6.5. I am sure it would work fine. then you can attemp further overclocks!

be sure to monitor the temp continuously and never let it go above 50~55.

Best of luck!

girish

<font color=red>No system is fool-proof. Fools are Ingenious!</font color=red>