Intel Celeron 810 overclocking

How do I adjust the core voltage. The VID Regulator needs to be disabled. How do I do this? HELP HELP HELP!!
Thanks
1 answer Last reply
More about intel celeron overclocking
  1. OK, I put this out there in the CPU forum a while back, but people don't seem to remember that far back, and it's not in the overclocking forum. YOU CAN OVERCLOCK TO THE NEXT AVAILABLE BUS SPEED ON ANY MOTHERBOARD as long as there is a higher bus speed supported by the board! Some guy is driving me nuts about it so here's you answers!

    Bus Frequency Detection:

    BSEL1.....BSEL0.....Bus Frequency
    Closed....Closed....66
    Closed....Open......100
    Open......Closed....133


    Core Voltage:

    Vid3......Vid2......Vid1......Vid0......Core Voltage
    Open.....Closed...Open.....Open.....1.50v
    Open.....Closed...Open.....Closed...1.55v
    Open.....Closed...Closed...Open.....1.60v
    Open.....Closed...Closed...Closed...1.65v
    Closed...Open.....Open.....Open.....1.75v
    Closed...Open.....Closed...Open.....1.80v
    Closed...Open.....Closed...Closed...1.85v
    Closed...Closed...Open.....Open.....1.90v
    Closed...Closed...Open.....Closed...1.95v
    Closed...Closed...Closed...Open.....2.00v
    Closed...Closed...Closed...Closed...2.05v

    As you can see, changing a low-voltage Celeron, such as the 566, from 1.50v to 1.90v only requires closing Vid3

    Changing a 1.65v CBo PIII to 2.05v requires closing Vid3

    Changing a 1.70v CBo PIII to 1.90v requires closing Vid2


    Those are the easy adjustments. But you can use the chart to come up with almost anything you want. Since your using an OEM board, I suggest making the mods to the board instead of the processor if you think your processor is worth more. If your using a slot 1 board, I suggest an Abit Slotket III instead, part number 707603 at http://www.googlegear.com

    You can download the pin charts (along with the information I just provided) from Intel. Here it is smartguy now leave me alone!

    If your running a cheap processor and would rather modify the CPU than the board because it's easier, you can use fine wire to close Vid pins by connecting them to VSS. You can open the pins by bending them flat, but they will probably break if you do it more than once. I rutinely break pins off Celerons to make them run at a faster bus speed.


    What's the frequency, Kenneth?
Ask a new question

Read More

Motherboards Overclocking Celeron Intel