Sign in with
Sign up | Sign in
Your question

Board too slow for cpu

Tags:
  • CPUs
  • Overclocking
Last response: in Overclocking
Share
June 19, 2002 10:44:05 AM

This is my third try so ill be brief.
I have an Azza PT-5IT m board,according to the manual it can't support a cpu speed faster than 266mhz(at least there isn't a setting for it listed.)
My processor is a cyrixinstead, in another system it ran at 333mhz without overclocking(that board is dead).
I was asked in a previous posting for the bios i.d. These two lines are case correct, the first one is above the ram test,the second is in the bottom left of screen.
12/04/97 w83977TF for PT-5IT
11/18/97-i430TX-2A59IP89C-00
All the 0's are zeros
What i want is info on which jumpers effect the frequency multiplier, what configeration to use,and what jumper config I should use for the cpu in regard to the changes i want to effect(the cpu running a 333/366mhz).Well so much for this being brief, I'll sign of by saying HALLLLP!

later....

More about : board slow cpu

June 21, 2002 5:21:55 PM

you need to find the manual for your board. it has all the switch settings in it.

how do you shoot the devil in the back? what happens if you miss? -verbal
!