2215/Moto V600/Corp Network Blues

Archived from groups: microsoft.public.pocketpc (More info?)

I just obtained a Moto V600 and hoped to use it as a
modem with my 2215 via BT to connect to my corporate
network. I have routinely dialed in using my CF modem and
configured the BT modem setup the same. However, when I
tell the 2215 to dial using the BT settings, the phone
dials the correct number, then disconnects. Now, it may
be that my data service is not enabled yet, but I thought
I'd try the knowledge base here to see if there is
anything obvious I can do.

Settings are:

Name - BT US (or similar, I've set up a couple of
numbers)
Modem - Bluetooth Dialup Modem
Phone number - the correct number used with my CF modem
User name, password, Domain - all the same as used for my
CF modem
Baud Rate - I've tried everything from 57600 to 14400
Wait fro dial tone - checked
No wait for credit card
No Diall-string commands
Cancel if not connected in 120 sec
Data bits: 8
Parity: None
Stop bits: 1
Flow control: hardware
No terminal boxes checked
Use specific TCP/IP address - same as with my CF modem
Use software compression
Use IP header compression
Use server-assigned addresses

Any Ideas???

Kevy