Mitsubishi 2060u A+

My 2060u arrived yesterday. This thing is great!
It was worth every penny for this magnificent monitor.

Several sites complained about the complexity of the controls. I think they are great. They give precise control of the image over different areas of the screen. The have adjustments for different conditions/situations too allowing you to customize this monitor to your preferences and needs. I found them to be fairly intuitive requiring little consultation of the manual.

I have three tiny issues with this monitor. I am very picky. This monitor has been seriously scrutinized, and these issues are trvial to say the least.

1.) The text is not in *sharp* focus in the extreme corners relative to the rest of the screen. I'm talking the last cm of the corner where text is not normally displayed anyway.

2.)The bottom of the screen (the bottom edge of the task bar specifically)seems to have an ever so slight curve that I can't adjust out. I think its actually the bottom two corners lifting up about 1.5-2mm above the center.

These things are not noticeable without considerable inspection.

3.)My refesh rate at 1600X1200 is limited to 85Hz which is the reccomended resolution, but the spec sheet calims 95Hz is the possible at this res. I think it's my vid old 16MB Monster Fusion vidcard card.

I don't have the new machine assembled yet. It will certainly have a more powerful vid card capable of higher refresh rates at high res.

Everything else is absolutely perfect. Like I said it is worth every penny, and it looks great too.

Size wise it is perfectly on scale with my new Lian-Li PC-70 tower.

I would rate this monitor as one of my best hardware purhcases ever.