KV8 max3 uGuru problem

[Guest]

Archived from groups: alt.comp.periphs.mainboard.abit (More info?)

I temporarily disconnected the OTES and NB fans, and later re-attached
them. Now uGuru says they are not working, while in fact they are
spinning nicely. Is there any way of resetting uGuru so that it sees
them again?

 

[Guest]

Archived from groups: alt.comp.periphs.mainboard.abit (More info?)

Clear the CMOS; thats what ABIT says.

"Graham Phillips" <graham@gptwelve.com> schrieb im Newsbeitrag
news:7s0l60hgr9e62fie41oouilrnn4t4bq3r1@4ax.com...
> I temporarily disconnected the OTES and NB fans, and later re-attached
> them. Now uGuru says they are not working, while in fact they are
> spinning nicely. Is there any way of resetting uGuru so that it sees
> them again?

 

[Guest]

Archived from groups: alt.comp.periphs.mainboard.abit (More info?)

Thanks. I presume that means I will then have to completely re-install
everything; ... or is it posible to clear the CMOS without losing
everything?

On Thu, 1 Apr 2004 07:40:15 +0200, "Klaus Freiburg" <kfr0@cst.ath.cx>
wrote:

>Clear the CMOS; thats what ABIT says.
>
>"Graham Phillips" <graham@gptwelve.com> schrieb im Newsbeitrag
>news:7s0l60hgr9e62fie41oouilrnn4t4bq3r1@4ax.com...
>> I temporarily disconnected the OTES and NB fans, and later re-attached
>> them. Now uGuru says they are not working, while in fact they are
>> spinning nicely. Is there any way of resetting uGuru so that it sees
>> them again?
>