bd cycle error on digital ln-15 printer

Archived from groups: comp.periphs.printers (More info?)

Well, here's an update.

I've just got the machine online- thanks to the help from Paul
Anderson. Turned out to be the laser unit. "Laser not in start
postition" was reported. So I opened it up and noticed there was a
spring-loaded metal bracket which was blocking the beam. There seemed
to be no attachments, mechanically speaking, to this assembly.Perhaps
they'd been removed by a previous tech or owner.

Next step was: I temporarily taped the lever into its other position,
thus allowing the beam to reach the rotating mirror, applied power
and...that did it!

Now I just need to know where I can download a driver for win98 or
2000 so I can test /use the machine more fully!

thanks for your time and help.
Ben

reverend_rogers@yahoo.com (b) wrote in message news:<1cfa6663.0406020618.7cef162e@posting.google.com>...
> just got given this laser printer . during the warm up cycle the main
> motor turns a few seconds then the above message appears. has anyone
> seen or successfully repaired this fault ? I suspect it is caused by
> some problem on the gearing in the paper path or am I off -track? I've
> already removed the top and rear covers and saw nothing amiss.Should i
> just dump this thing? any suggestions appreciated.
> Ben