GA-Z77X-UD5H doesnt support 32gb Ram?

[alexherreraz]

i have a huge problem, i just make work the Mother board adding 2 8gb slots, one in slot DDR3_4 and DDR3_2, but when i try to add two more on DDR3_1 and 3 it starts to beep and after turned off, what can i do??

i uploaded this video to show the problem http://www.youtube.com/watch?v=5jiLuFyyUk0

Specs: Gigabyte Z77X-UD5H
4 8gb Rams like this: http://www.dimercom.mx/image/cache/data/ADATA8GB-500x500.jpg
2tb HDD
Intel Core i7 3770 3.40ghz
Nvidia GTX 650 Ti 1gb
800watts

I have tried to connect the rams in slots 2-1, and 3-4 as the manual said but it doesnt works

 

[chugot9218]

Are they all the same sticks, or ideally purchased as one set?

 

[alexherreraz]

Are they all the same sticks, or ideally purchased as one set?

thanks for the help =)

what you mean with the same sticks? i been buying one per one with the same guy, but as i said, they are the same memories, trademark, mghz, everything

 

[chugot9218]

RAM can be a little finicky, they should be all the same speed and have the same timings for them to work best together. When RAM is packaged at the factory, the sticks are tested to work together (so a pack of 4 sticks is tested together before leaving the factory, to make sure they do work fine together). Thus, it is best to buy all the RAM in one swoop. Sounds like you have at least one bad stick, or if you haven't had RAM in the other slots before, a bad slot or two. I would test pairs of the sticks in the 2 banks you know are good, and see if you run into issues with any set of 2, that would likely tell you whether your RAM is bad or one of your DIMM slots.