OC in progress!

[Maxiius]

I upped the FSBor whatever its called to 220 which puts me at 2890ghz and the computer boots up fine and runs normal, but when I run Prime95 it shoots an error back after about a minute or 2. I read through the stress readme, and said try upper vcore or adjusting mem timings.

I know how to adjust these in the bios, but when it comes to adjusting mem timings, I have no f'in clue what i'm doing hehe. Just want to get some opinions on what to do next? I thought uppering the vcore was last on the list to do, so I figured i'd try to mess w/ mem timings b4 doing that. Any suggestions?

 

[EllisD420]

DFI-Street Overclocking Guide

Check out this link above, before you venture too much into overclocking you should understand what your doing. This guide is good even if you dont have a DFI motherboard. So i would take a look at what it has to say and go from there.

 

[Maxiius]

Will have to check out that link later, internet has it blocked at work :roll:
Thanks