Tom's Hardware > Forum > General Networking > VPN, VoIP, Video Conferencing, Remote Connections > Netgear RP614 and VPN
Ask the community Add a reply
Word :    Username :           
 
Anonymous   11-07-2004 at 02:25:32 AM

Archived from groups: comp.dcom.vpn (More info?)

 

I've seen a couple of older postings on this, so I thought I'd put
in my experience. I bought a netgear RP614 router in October 2004
and it worked ok out of the box with my Cisco VPN client.
I then upgraded to the latest 5.20 firmware off the netgear website,
and couldn't maintain a tunnel, even after following their
suggestions on port forwarding.

My solution was to back off to the prior FW 5.14 (don't recall what rev
the original factory fw was.) VPN is now working fine without
any special port forwarding/triggering.

-david i

Add a reply
Sponsored Links
Register or log in to remove.
Ask the community Add a reply
Tom's Hardware > Forum > General Networking > VPN, VoIP, Video Conferencing, Remote Connections > Netgear RP614 and VPN
Go to:

There are 1396 identified and unidentified users. To see the list of identified users, Click here.

Forum map
Bestofmedia Forum ©
2000-2009 Bestofmedia Group
Page generated in 0.263 seconds
Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
Related Topics
See all relatives topics
They won a badge
Join us in greeting them