A8N-SLI Wacky Adventures..!

so i have a A8N-SLI and my current clocks of 2.753 is not quite high enough for me.. ..

so i am wanting to do a vcore voltmod.

since the board wont go above 1.584v and i have adaquate cooling (the load temp is around 45c and i should be recieving my water setup soon.

. since this board is pretty cheap im not too fussed if i fry it.. but im an average solderer.. and have seen many a voltmod guides on vr-zone but alas the pics just dont seem to load.. i would appreciate any advice anyone could offer..
as far as i can tell you solder a 10k trimpot to some point on the board and then ground the other end and set the resistance up duper high. and fiddle dee dee.. you can add more volts..

sys specs are as follows..

venice 3000+ @ 2.753___1.583v
a8n-sli
bunch of cheap ram
2x sataII 250gb raid 0
2x xfx 6800gs xxx @ 520-530/1280
1 x 10gb crud sys disk
antec sp2.0 500w