Audigy2 Plat internal breakout box / headphones / remote

Hi

Im struggling with this! The remote doesnt do anything, and if I plug headphones in the sound still comes from the speakers, and speakers only. No headphone sound at all.

I have checked the box in settings that says mute speakers when headphones connected. Nothing.

The remote doesnt seem to do a damn thing either, im actually wondering if the breakout box is functioning at all. It is obviously connected to the sound card with the enclosed ribbon type cable.

Any ideas please?

Im still getting horrendous feedback too with mic volume at any level and speakers more than 10-15% volume.

Grrrrrrr.......

Whats that got to do with it? You got me!

FYI all levels are 3/4 to full. If you are responding specifically to the feedback issue, i've tried about every possible level of volume for Mic.

Cant see what the levels have to do with the breakout box not working with headphones?

Hmmm...I'd say try the following:

1) disconnect/reconnect both the ribbon cable and the floppy-drive power connector that is used

2) if you're not already using Creative's very latest drivers than un-install the current drivers and install the latest set from Creative's website

3) the remote. I'm not sure if the remote only works fully with the Creative Media-Center type software or not (a forum member with the same set could clarify)