Archived from groups: comp.dcom.xdsl,comp.dcom.wan,comp.dcom.lans.ethernet,comp.dcom.lans.misc,comp.sys.dcom.xdsl (More info?)
I have two SHDSL 4wire 4.6Mb/s MODEMS for sale.
They can be used with North American *or* European
protocols separately or together as back to back over any
5 miles / 8 kilometers of 4 wire cable with up to
4.6Megabits/second in full duplex. They will also 'fall back'
to 2wire operation at 2.3Mb/s if a pair fials.
best offer
The kits have wires and cables and manuals and cdroms
and I have extensive support knowlege as well on these
items. One of the two is a CO mode so with the pair,
you can bridge over the 22500 ft at full symetrical rates
approaching 4600Kb/s. Over plain 4 wires, which connect
to on RJ11 jack. The modem pair runs two or four pairs
automatically and seamlessly. Either modem have a small
HUB, not a switch, with collision type connections, so
we always used them with just one port. The have WEB
browser setup, and I set the pair to 10.0.0.1 and .2 for
simplicity. They use the ATM things to push IP along,
and they have some route capability, but we just used them
as ethernet extension in campus enivronments. Simple,
effective, quick to sync up, no fans, built in AC/no bricks,
flat 1.75" high with feet, they dont overheat,
newer 10/100 dual activity LEDs on all 4 ports, MDIMDI-X.
Lots of diagnostics via the serial CLI port.
(I think), made by TelMax (very similar to xTreme5100).
I have one picture link here
http://www.vif.com/users/radcom/fo [...] _pair!.jpg You connect these modems over dry pairs,
not normal POTS, and while they work fully with
Alcatel DSLAMs 7xxx, I am selling the pair
as ethernet extension bridges asking $600 US for the
pair only, and I can provide DOA warranty but
shipping and insurance is extra/negotiable.
In 2001 the early non-route models were $699 US MSRP
each.
I also have 2.3Mb/s modems as well(4 pairs)
you can either email me at
r a d c o m t e c h (at) g m a i l (dot) c o m
[yes you will have to manually put the address together
unless you are spammers 'bot in which case -go away]
or call me
John 613-224-2922 at night and leave a message
BTW; you can drop the G. part from SHDSL,
G.991 is ratified/its not a draft anymore.
