I have tried both the jumper mod and making my own bios through ITK and both at the same time!!! I can't get my PC to post at 1333.
I have a e6400 and when I did the jumper mod I did get control over the FSB however whenever I set the bus speed to 1333 the PC would shut itself of turn back on post but my settings wouldn't be saved. Once I got back into the bios I notice the fsb was as 1333 but it said my CPU was at 4.66 GHz? So I tried 533 FSB and it set teh CPU at 1.86. Its like it set my muliplier to 14? WHY!?!?!
This is the case with both 1304 and 1334 versions of the bios.
So I tried to use ITK made my own bios with the multi set and locked at 8 and it still will not post with or with out the jumpers solderd with conductive ink. What am I doing wrong? It jsut reverts back to the default config.
Mind you this board CPU will run at a higher FSB that this using 1066 = 30%. But I top out at 2.77 GHz (see SS below).
http://www.prntscrn.net/img.php?img=10hr.jpg
Why can't I use 1333 as a starting point?
I have a e6400 and when I did the jumper mod I did get control over the FSB however whenever I set the bus speed to 1333 the PC would shut itself of turn back on post but my settings wouldn't be saved. Once I got back into the bios I notice the fsb was as 1333 but it said my CPU was at 4.66 GHz? So I tried 533 FSB and it set teh CPU at 1.86. Its like it set my muliplier to 14? WHY!?!?!
This is the case with both 1304 and 1334 versions of the bios.
So I tried to use ITK made my own bios with the multi set and locked at 8 and it still will not post with or with out the jumpers solderd with conductive ink. What am I doing wrong? It jsut reverts back to the default config.
Mind you this board CPU will run at a higher FSB that this using 1066 = 30%. But I top out at 2.77 GHz (see SS below).
http://www.prntscrn.net/img.php?img=10hr.jpg
Why can't I use 1333 as a starting point?