Unsupported clock generator PLL

juffi

Distinguished
Oct 5, 2006
5
0
18,510
I have an Asus Pundit-R which has Asus P4R8L motherboard based
on ATI Radeon 9100 IGP. No overclocking capabilities in the Bios.

On the clock generator PLL chip is printed:

ICS CJ860070
0507
93776AF

ClockGen does not recognise the PLL. Systool does not support the PLL.
What other overclocking software I could try? I have a Northwood 3.2G
P4 which would overclock easily.

Any advice how to go forward would be appreciated.
 

juffi

Distinguished
Oct 5, 2006
5
0
18,510
Were you really thinking of overclocking an IGP????

I still am.

I might be undereducated here but I cannot see any reason why
changing FSB 10% higher would not be possible.

I already changed display controller frequency from 300 MHz to
343 MHz without problem.

My understanding so far is that I only need a simple piece of SW
capable of setting up the PLL.
 

juffi

Distinguished
Oct 5, 2006
5
0
18,510
Well, Pundit-R is very small and real quiet after changing the power and CPU fans. This computer is the media center in my living room. Only problem with Pundit is a little jerky HDTV picture with high bitrates.

Changing the system is therefore more size and noise issue. I haven't yet found a suitable system. Requirements:
- Pundit-R size (max. 15x35x30 cm)
- Vertical position
- Very quiet power
- SW adjustable CPU fan
- Two PCI slots
- 4 USB2
- Display controller without fan (preferably X1300 for H.264)
- SPDIF sound output
- Cardbus

Any proposals here?
 

juffi

Distinguished
Oct 5, 2006
5
0
18,510
I found out that the clock generator is integrated into the 9100 IGP chipset. Quite low chance to find SW supporting it.
 

overclockingrocks

Distinguished
Oct 9, 2006
379
0
18,810
not to mention the fact that if you did that and something fried then you can't just plug in a new graphics chip because most likely you friend some other chip because integrated graphics aren't a separate chip so you may fry north or south bridge trying. My point is that it's not worth the risk due to the gain being little to nothing. just buy a new graphics card and oc that if you want then at least if something happens you can replace it.

Just trying to help,

overclockingrocks
 

juffi

Distinguished
Oct 5, 2006
5
0
18,510
I do not need much overclocking, 10% would be enough. My earlier 3.0G Prescott is quite a heater and the new Northwood 3.2G with 10% overclocking would probably run cooler.