Help me make my final water cooling decision!

Ok, I have been deliberating for many weeks on how I want to water cool my PC. I am only going to be cooling CPU (D805 @ 4.0Ghz+) for now.

Here are my choices:

1) Swiftech H20-220 Apex Ultra---$240


2) Swiftech H20-120 ---$150

3) DIY kit with the Apogee block used in both kits above, Danger Den MAG II LE pump, Swiftech Dual 120mm Rad, and using a T-Line and Fill-Port.---$190

What I'm asking is what do you guys all think I should do. I would like to keep it internal (Option 2) but it might not even be possible to fit it in my Antec SuperLanboy case.

Does the performance addition of the dual rad kits (1 & 3) outweigh the price increase? I was hoping to spend under $200 but if the Apex kit is going to be better, I can probably swing the extra $40/90.

How much performance increase can I expect going from a single 120mm rad inside my case (2 fans in push/pull) to a dual rad outside my case with 2 fans (push/push or pull/pull?)

Has anyone used UV dye inside UV tubing? For example, blue UV tubing with red UV dye, I think it may look coool with a red/purple core and blue outside.

Can you show me where I can build the kit #3 for $130? Cheapest I can find is about 190 shipped, not sure what I'm missing...

Been browsing eBay very much in the last couple weeks, haven't ran across but a couple Apogee blocks that sold for more than websites charge and havent seen a single Storm. A few TDX's but they are all buy-it-now for overpriced. I will continue lookin though.

Thanks for the tip on the guide, very nice!

I have a week old water cooling set that I am reselling.

You can see what it contains here: Water Cooling Set


If anyone is interested just send me a message.

Is the A64 version the same block inside? That doesn't seem like it would be a tough mod. My grandfather has a laser cutter that could easily cut a piece of 1/8" steel or something and drill the holes in it.